DM9 trouble

[Xmini-ballerX]

Well I was at training yesterday the gun was working fine then about half way through the day the first few shots I made wouldn't go anywhere it seemed they just dropped out the barrel but when it goes into ramp it shoots fine. I turned the velocity up to see if that was the issue but it wouldn't go any higher than 260 fps . Any help ? , thanks

 

[soul snatcher24]

first step is to make sure the bolt system is clean and properly lubed

then change the battery to a fresh good quality one

then on the board make sure that dip switch one is up and two is down (this means that anti bolt stick is on)

reset the LPR, this video should help:

and set the dwell to 18ms if it isn't already

these steps should sort out your problem, if not try replacing the bolt sail o ring (shown in video above)

hope this helps
Ryan, team domination

 

[Fly]

Yeah it's bolt stick mate, as soul said check your bolt, make sure it's lubed up etc