Creed Help

[Ryan.Grainger]

Hi people, the pin going to the micro switch on my creed keeps on coming loose how do i prevent this from constantly happening, also how do i set my lpr and stuff?
Thanks

 

[soul snatcher24]

a pic of the pin going to microswitch might be usefull if anyone is to give a solution

the LPR is adjusted using the screw at the front of the gun underneath the barrel, to turn it up turn it counter clockwise (out) and down is the opposite, however if your gun is shooting fine then i wouldn't worry about playing with it

hope this helps
Ryan, team domination

 

[Ryan.Grainger]

Picture

a pic of the pin going to microswitch might be usefull if anyone is to give a solution

the LPR is adjusted using the screw at the front of the gun underneath the barrel, to turn it up turn it counter clockwise (out) and down is the opposite, however if your gun is shooting fine then i wouldn't worry about playing with it

hope this helps
Ryan, team domination

 

[soul snatcher24]

which bit in the picture is moving?

 

[Mclovin101]

Lock tight the blue one mate. Get it set up and just use a small amount of it.

http://www.vanguardpaintball.com/

Read the manual

Creed manual
http://www.creedmarker.com/manuals/Creed_Quickstart.pdf

Creed Tuning, Velocity adjustment guide
http://i529.photobucket.com/albums/dd334/shootnpoo1/Creedvelocityadjustment.jpg
Oring guide
http://i529.photobucket.com/albums/dd334/shootnpoo1/oringassys.jpg

 

[foot]

Hi people, the pin going to the micro switch on my creed keeps on coming loose how do i prevent this from constantly happening, also how do i set my lpr and stuff?
Thanks

Hi Ryan,

i replyed to your pm before i read this.

Follow Mclovins links, they will help.
Although with the light weight rammer installed you will be able to run your dwell slightly lower.

 

[foot]

the LPR is adjusted using the screw at the front of the gun underneath the barrel, to turn it up turn it counter clockwise (out) and down is the opposite,

Almost right but the other way around

lpr is out for less, in for more, but dont screw in past flush on the lpr cap.